|
|
|
|
|
|
Motorcycle LED Light Bars & Ultra LED Light BarClick Here for Ultra LED Light Bars
Motorcycle LED Light Bars
by Signal Dynamics These high intensity LED products are designed to give greater visibility and conspicuity to your motorcycle. They are unique, because they have been engineered to function in both high and low intensity brightness for a multitude of applications. Because many motorcycles have only one brake/running light bulb, these units can easily be used as back-up brake, and running lights, providing you a greater degree of safety. Mount the Universal Light Bar anywhere you want or need more light - on saddle bags, tour packs, sissy bar, rear fender, trailer, or custom installations. These LEDs light bars were designed to be auxiliary running/brake or running/turns signals and not a direct replacement for your OEM lights. These lights are NOT DOT certified.
By Signal Dynamics
Operates 9-16 Volt DC Systems 3 LED Configuration Rated at 100,000 Hours of Service Life Shock and Vibration Proof No Corrosion Impact Resistant Polycarbonate Housing Energy Draw 250 Milliamps Interchangeability with Most Manufacturers 3 wire Required for Trailers, Campers and Trucks Over 80" in Overall Width 15.50" x 1.60" x .80
Knight Riderz Sequential LED Light Barby Custom Dynamics
This light bar contains 12 high power intensity LEDs. In running light mode the LEDs sequence from side to side in a "Knight Riderz" sequence. When the brake is applied the LED will flash for approximately 5-6 seconds then go to a solid on state until the brake is released. Both modes, running and brake, have been designed to create the maximum viability. The unit comes pre-taped with 3M double sided tape for easy mounting to any flat surface. Simply connect the black wire to any ground wire, the Red wire to your exiting brake light wire and the blue wire to an existing running light power source. Works with any 12VDC system, no load equalizer or resistors required. Dimensions: 4.7" long x .7" wide x .7" high.
Knight Riderz Non-Sequential LED Light Bar
This light bar contains 12 high power dual intensity LEDs. In running light mode the LEDs are on in low intensity mode. When the brake is applied the LED will flash for approximately 5-6 seconds then go to a solid on state until the brake is released. Both modes, running and brake, have been designed to create the maximum viability. The unit comes pre-taped with 3M double sided tape for easy mounting to any flat surface. Simply connect the black wire to any ground wire, the Red wire to your exiting brake light wire and the blue wire to an existing running light power source. Works with any 12VDC system, no load equalizer or resistors required. Dimensions: 4.7" long x .7" wide x .7" high.
Knight Rider Non-Sequential LED Light Bar with NON Flashing Brake Alert
Not into the sequential or flashing LEDs, this light bar is for you. This light bar contains 12 high power dual intensity LEDs. In running light mode the LEDs are on in low intensity mode. When the brake is applied the LED will then go to full intensity mode. The unit comes pre-taped with 3M double sided tape for easy mounting to any flat surface. Simply connect the black wire to any ground wire, the Red wire to your exiting brake light wire and the blue wire to an existing running light power source. Works with any 12VDC system, no load equalizer or resistors required. Dimensions: 4.7" long x .7" wide x .7" high. These lights bars can be used as running, brake, and turn when used in conjunction with one of our controllers.
|
|
