LED Accent Lights

• Use Tie wraps for extra security when installing ground effects lights or bag rail lights.

• Test lights using a 9V radio battery for operation and placement before installing.

• Use large tie wrap (available at Home Depot) to feed wires through tight places, drill hole in one end of tie wrap to pull wires.

• Use McGuire's  Ultimate Quick Detailer to clean 3M primer off painted and chrome surfaces.

• Clean surfaces with rubbing alcohol before cleaning with 3M primer.

• Loosen Tank Bolt and slightly lift tank with rubber door stop or  a roll of electrical tape to give more clearance while installing lights.

LED Bullet Turn Signals

• Be sure black rubber gasket is fully seated before inserting LEDs, push rubber gasket in with small flat head screw driver if necessary.

• Be sure Base is inserted correctly, you can insert a 1157 backwards

• Insert Base then twist Cluster to coil wire

• HD Bullet Turns do not need trimming. Be sure cluster is properly Seated and quickly snap lens into place.