Customer Write-Up

I picked up one of your LED Signal Flashers yesterday for my Suzuki
SV1000S (2003) based on some info I pulled off the SV users group web page.

When I was talking to your folks in the store I mentioned the
modification to the Suzuki that allows the use of the universal solid
state relay without any wire cutting etc., attached are some pictures of
the installation.  The OEM Suzuki flasher is part of the side stand
safety/diode module.  The pictures show the removal of the two wires
from the Suzuki module and then direct connection to the solid state
relay.  I used a very small jewelers screw driver to depress the keepers
on the Suzuki module and the solid state relay plug,  The wires slipped
right out, no problem.  I put some heat shrink tubing over the
connections and zip tied the relay to the tip over sensor under the
seat.  The whole thing took about a 1/2 hour to 45 minutes.

Not sure how many Suzuki models this will apply to but I have noticed
there is never a replacement relay listed for any of the Suzuki's.

Courtesy: Steve & Greg on the SV Portal