|
|
|
|
|
Upcoming Rally: Myrtle Beach,SC May 15-20 Cali Bakers Firehouse (Next to Hooters) North Kings Hwy (17) Map
Upcoming Rally: Myrtle Beach,SC May 15-20 Cali Bakers Firehouse (Next to Hooters) North Kings Hwy (17) Map |
|
Hyper-X High-Power LED Modules and Driver Introducing a match made in engineering heaven: A 1 Watt LED,
and a dual intensity current regulating driver.
Hyper-X High-Power Led Module
1 Watt LED, mounted on heat-sinking aluminum PCB.
The Hyper-X LED Module is a High-Power 1 Watt LED module that produces an incredible amount of light. This module is designed to operate in conjunction with the Hyper-X LED Driver to provide dual-intensity (3-wire) operation of the LED. They are currently available in: Red, Amber, White and Blue for a variety of applications. Measuring only 20mm (0.78") in diameter, its about the size of a Nickel, and puts out as much light as a 10W bulb, while only consuming 1W of power. This product is extremely versatile for custom applications where high-intensities or small sizes are required. Retrofitting existing housings and enclosures with this LED module is as simple as gluing it in place. For more secure installations, the two notches can be used to center mounting screws.
Up to three red or amber Hyper-X LED Modules can be run off of a single Hyper-X
LED Driver, and up to two white or blue Hyper-X LED Modules can be run off of a
single Hyper-X LED Driver! The Custom LED Hyper-X LED Drivers come with
The modules are not waterproof and are intended to be mounted inside of a suitable enclosure.
The Hyper-X LED Modules have the following specifications:
LED Wattage class: 1 Watt
Size: 0.78" Diameter,
0.15" Thick (with wires)
Current draw: <350mA
(bright)
Waterproof: NO
Viewing Angle: 120 Degrees
Blue Intensity: 12~20
Lumens, 465~475 nm
Red Intensity: 45~70
Lumens, 624 nm
White Intensity: 114~138
Lumens, 6000K
Amber Intensity: 45~70
Lumens, 598 nm
Hyper-X High-Power Led Driver
 Solid-State, Current Regulating, Dual Output driver for Hyper-X LED Modules. The Hyper-X LED Driver is designed to power the Hyper-X LED Modules with dual-intensity and current regulation. The driver has two inputs (dim/bright), and one output to connect to the Hyper-X LED Module(s).
One single Driver will power up to 3 red or
amber LED modules, and 2 white or
blue LED modules when wired
The Hyper-X LED Driver has the following specifications: Input Voltage: 24vdc max, min depends on number of LEDs driven. Size: Approximately 2" x 0.4" x 0.81" Current draw: <350mA (Bright) Waterproof: YES
|
|
