J&M Corporation Complete Portable
 Motorcycle Audio System 

The Integratr IV

by J&M Corporation

This Complete & Portable Motorcycle Audio System Features:

• FM Stereo Tuner
• Driver/Passenger Vox Intercom
• Aux Stereo Input for Mp3 - iPod Type Music Devices
• Belt Mounted Leather Pouch for Easy Access While Riding

Additional Accessory Cables Also Available for:

• Cell Phone Integration
• 40ch CB or FRS/GMRS Two-Way Radio Integration
• Navigation/GPS Audio Commands
• ACC Warning Devices (Radar) Audio

The Integratr IV is powered by 8 AAA alkaline batteries (Approx. 16 hours of continuous operation) or the optional rechargeable polymer lithium ion power pack

Installation Manual

Integratr IV Audio System Kit
 (includes belt pouch & aux input cable)

Featuring a built-in FM stereo tuner, aux input for Walkman/MP3/IPOD type music devices, J&M’s DynaVox driver/passenger intercom, optional 40ch CB/FRS/GMRS portable radio connection, along with inputs for your cell phone, GPS audio and radar detector signals, all in one compact portable package that will go with you anywhere.

The INTEGRATR IV will run for over 16 hours continuous using 8 AAA alkaline batteries or you can use the optional, rechargeable Polymer Lithium Ion battery pack.

The performance of this new unit will rival that of ANY motorcycle audio system on the market today, factory installed or aftermarket.

JMSR-4020 kit includes the Integratr IV main unit, alkaline battery tray, leatherette/vinyl belt pouch, aux music input cable and complete operation/owners manual.

Important Note: The INTEGRATR IV is a J&M 6-pin audio system that requires the pre-amplified microphone signal provided by our Dual Mode helmet headsets along with the HC-ZWY or HC-PWY lower-section hook-up cord. (Please see the headset pages)

Integratr IV Connection Cable for
 Garmin Zumo550

This new cable from J&M will connect the base cradle of the Garmin Zumo550 to the cell-phone input of the J&M Integratr IV, to provide GPS Route commands, cell phone integration thru the Bluetooth link inside the Zumo550, along with stereo MP/3 and XM satellite radio (if Zumo550 is so equipped) audio into the J&M Integratr IV for both driver and passenger enjoyment.

Daytona Gear Leather/Magnetic Integratr IV
 Storage Pouch

This is a top quality glove soft leather pouch assembly from Daytona Gear, manufactured to the correct dimensions to hold not only the J&M portable Integratr IV audio system, but also has enough room for your favorite I-Pod, cell phone and/or FRS radio as well.

This pouch assembly uses small Neodymium magnets for unbelievably strong attachment strength, even at high speeds, to most any steel fuel tank or handlebar assembly (will not adhere to stainless steel) and under most circumstances will not scratch your paint.

This is a must-have accessory for those riders not wishing to mount the J&M Integratr IV unit to their side or belt.
 

Cell Phone Input Cable for Integratr IV (3-pin)

This cell phone input cable will connect most cell phones utilizing the standard 3-pin headset jack, to the integratr IV.

To adapt this cable for 4-pin type cell phones like the Nokia brand, you will also need the 3 to 4-pin adapter cable, J&M part# JMSR-AC92 that is also listed in this section.

3-pin to 4-pin Cell Adapter for use with
 Integratr IV

FRS/GMRS Connection Cable for Motorola T-Series
Portable Transceivers

This cable will connect the Motorola T-Series (single plug type) FRS/GMRS portable hand held radios to the J&M Integratr IV audio terminal.

FRS/GMRS Connection Cable for Kenwood FreeTalk
 Portable Transceivers

This cable will connect the Kenwood FreeTalk FRS/GMRS portable hand held radios to the J&M Integratr IV audio terminal.

Valentine One Connection Harness for
 Integratr IV

This is a direct plug-and-play adapter harness to connect the Valentine One radar detector to the J&M Integratr IV (JMSR-4020) portable audio system. (Valentine remote head not needed)

This unique adapter cable system also plugs into the Integratr IV’s 12v out jack to power the Valentine One from the battery or power source provided by the Integratr IV.`

Headset volume of the radar beeb/brap signal is adjusted with the small screw on the harness adapter.
 

Remote PTT/Mute Switch with Passenger Extension

This kit provides a handlebar wrap PTT and audio mute switch assembly, along with a passenger headset extension cable for connection to the J&M Integratr IV audio system.

This kit is needed when riding with the Integratr IV in a remote location such as a tank bag.
 

Navigator Audio Input Cable for Integratr IV

This cable can be used to connect the audio signals from most navigation (GPS) devices to the J&M Integratr IV audio system.

For those navigation devices that do NOT utilize the standard 3-conductor 3.5mm audio jack, the end of this cable can be cut off, wire ends stripped and spliced to the audio output wires with most of these types of devices.

The printed +/- wiring color code for this cable is included.

Highway Alert (radar) Input Cable for Integratr IV

This cable can be used to connect the audio signals from most radar signal devices to the J&M Integratr IV audio system.

For those highway alert (radar detector) devices that do NOT utilize the standard 3-conductor 3.5mm audio jack, the end of this cable can be cut off, wire ends stripped and spliced to the audio output wires with most of these types of devices.

The printed +/- wiring color code for this cable is included.

Polymer Lithium Ion Power Pack for Integratr IV

Polymer Lithium Ion power pack (only) for the J&M Integratr IV audio system.

Recharging kit for this power pack is sold separately on this site, J&M part # JMSR-AC09.

Charging Kit/Lithium Ion Power Pack for
 Integratr IV

Complete charging kit (120/240v AC, 12v DC auto) to recharge the optional polymer lithium ion power pack for the J&M Integratr IV audio system. (kit includes international power adapters)

12v Car Type Plug Adapter for Integratr IV

JMCB-2003 Mounting Bracket Kit (only) for ‘08 Kawasaki Concours14