Milwaukee Magic™ Install Instructions

After using the standard tube instructions for wire terminal installation.

Run wires to the area above horn bracket.

The tube mounts sit one on each side of bracket with forward edge aligned with bracket bend.

Clean area where the tube mounts will sit with rubbing alcohol.

Next, trial fit tube before removing backing from vhb tape.

Adjust mounts as needed to get best flush fit on horn bracket.

Wipe down mount area with promoter pad. Let dry.

Install wires onto the tube.

Remove backing from vhb tape press mounts firmly into place being sure mounts sit flush and flat.

Finish running wires to their respective locations.

Use clip to hold wire together up above and behind horn bracket.

Run bike and adjust as needed.