PHOTOS FOR INSTALLING Right Magic

Thanks for stopping by Custom Dynamics. Sit back, relax and take your time there's a great deal to see!

If you have any questions at all, please feel free to drop us an E-Mail or call us
TOLL-FREE: 800-382-1388
(Local/International: 919-554-0949)

V-Twin, Chopper, Sportbike or Metric Cruiser, there's literally EVERYTHING To Light Up Your Ride!

Look for New Genesis LED Technology - 30% - 50% Brighter LEDs - Guaranteed

PHOTOS FOR INSTALLING "RIGHT MAGIC™" ON THE RIGHT SIDE


No Magic Neon's Right Magic™ has been designed to be installed on Harley-Davidson style motorcycles. Using either a round stock Evo style air filter, a new twin cam style air filter, or a stock Sportster style air filter, it has also been designed to fit on bikes that use a non-crossover or non loop over cam cover style exhaust. If you have any other bike or exhaust system, these install instructions may not be for you. Although the Right Magic™ will work on any engine or bike, clearance is the only limiting factor. If you have a bike other than those mentioned, you will have to make your own mounting brackets. Doing so will be at your own risk for tube damage and or breakage. It is recommended that you run the Right Magic™ tube off the rear cylinder coil wire. Although not totally necessary to do so, these instructions will assume you are doing so. Run and route wires and tube to front cylinder first using our normal instructions and photo install page. Then while leaving rear cylinder undone begin installing Right Magic™ tube kit.

Run the supplied wires that came with Right Magic™ through the space between cylinders at lower part of "v". The lower wire coming out of the Right Magic™. Is the wire that gets hooked to the rear cylinder. Ether in line with the remaining tube for that cylinder or run directly to the spark plug if you are using a Right Magic™ alone. Run the top wire from the Right Magic™ to the coil socket for the rear cylinder. Trim and attach as you did for the front cylinder.

After running wires, before removing the backing from the 3m VHB tape on tube mounts, trial fit tube to air filter housing. Making sure mounts sit flat and flush with air filter housing surface. Adjust as needed.

Make sure air filter housing is free from all grease, dirt and wax. (it is recommended you first wipe down housing with rubbing alcohol to make sure it is clean). Next open provided 3m Promoter Packet, being careful not to get any of the promoter anywhere but on the housing. Wipe area where mounts will sit with promoter pad. Let air dry.

Remove backing from 3m VHB tape on mounts being careful not to move their adjustment. Slowly place tube under air filter housing in desired location and press firmly in to place.

Run lower wire from Right Magic™ through wire loom on left side of bike as you did for front cylinder wire. Screw remaining tube on wire coming from Right Magic™. Run to rear cylinder as you did for the front tube. Adjust as needed.

Start bike and check for clearance on tubes. Adjust as needed.

Note: Do not stare at tubes while riding, we know you will be tempted to do this. Doing this tends to result in road rash!

The images and other content contained in this web site are the property of and copyrighted by Custom Dynamics® LLC. Downloading of images for personal use only is permitted. Downloading of images or text for commercial use without the written consent of Custom Dynamics® LLC is strictly forbidden. Custom Dynamics® and the Custom Dynamics® logo are registered trademarks of Custom Dynamics® LLC