Road Star, Royal Star, V Star - Flasher Replacement
 
Flasher wiring: 
Black wire - ground
Red wire – Input 12V

White wire – Output to Lights  

 Installation:
Unplug the factory flasher.

The flasher is located under the front of the tank or under the side cover below the right side of the seat.
 The plug should look like the above left picture.
Install male connectors on the ends of the new 3 wire flasher.
Insert the connectors into the factory plug as shown in the above right picture.
  Test the flasher to make sure that it is working properly.
  Adjust the flash to your desired speed by adjusting the dial on the new flasher.

ELFR DOT Flasher

Flasher Wiring:

Red Wire on Relay (Power) to Brown Wire on connector
Black Wire on Relay (Load) to Brown/White Wire on connector