Dynamic Clusters™  are a multi-color LED Clusters used for rear turn signal applications. The clusters contains 48 super bright LEDs. The outer ring contains Amber LEDS while all inner LEDs are dual intensity Red. The Amber LEDs are connected to a 1156 or 7507 base while the dual intensity Red LEDs are connected to 3' wire pigtails. 

These clusters can be wired as: Red low intensity Running light, Red High Intensity Brake Light, and Amber High Intensity Turn Signals, this allows your rear turn signals to be converted from simple turn signals to Dynamic running, brake, and turns signals, all in one unit!!! Installation is very simple, just plug the base to the stock turn signal housing receptacle, run the orange running light wire and the red brake light wires through the stock turn signal steams back to the taillight, connect the orange wire  to the stock running light and the red wire to the stock brake light wire with the supplied posi-lock connectors.

Dynamic Clusters™ can be used with Amber, Clear or Smoked Lenses, check out our lenses here. The Red LEDs are so powerful they will shine Red though most stock Amber lenses, however a more dynamic effect can be achieved with smoked or clear lenses.

Dynamic Clusters™ have a Life Time Warranty Against LED Failure.

Dynamic Clusters™ are NOT Dot approved, for off road or show use only.

A load equalizer may be needed to slow down turn signal flash rate.