Easy to install, LED fork wrap around with Amber LEDs that are encased in a flexible smoked, amber, or clear tubing. The ends connect with a zip tie like connection and all units come pre-taped with 3M™ tape for added security. Available for 39mm, 41mm, 43mm, 49mm, and 56mm forks. Product includes Stainless Steel Wire Loom and Chrome Tie Wraps for a professional & clean installation. Dimensions: 0.34" Wide X 0.30" High. Lifetime Warranty Against LED Failure. Sold as a Pair.
Amber LEDs will function as a running light and full contrast turn signal with the supplied harness. In order to have function as ONLY a running light or turn signal simply do not use the supplied harness and attach directly to the stock wiring on bike to pick up desired function.
If replacing stock turn signal bulbs, SMART Signal Stabilizer™/ Load Equalizer is required on 2013 & Earlier Sportsters®, 2011 & Earlier Dynas®, 2010 & Earlier Softails®, 2013 & Earlier H-D™ Touring and H-D™ Trikes and all V-Rod® Models to ensure proper function and flash speed of LED Turn Signals. For all other makes & models, SMART Signal Stabilizer™/ Load Equalizer is required if bike is NON-CANBUS.
39mm & 41mm = 35 LEDs Per Side
43mm = 40 LEDs Per Side
49mm = 45 LEDs Per Side
56mm = 50 LEDs Per Side
Note: If your size fork is not listed please select the next size down. There will be a small gap on the back side of the fork where the LEDs do not touch.
Note: This product is designed and intended for use as auxiliary lighting only. It is NOT intended to replace any original equipment lighting installed on the vehicle and should not be used for that purpose. This product must be wired so that it does not interfere with any original equipment lighting
Amber Running Light
Full Contrast Amber Turn Signal
Amber, Smoke or Clear Tube
LEDs Spaced 1 mm Apart
Dimensions: 0.34"W X 0.30"H
120 Degree Viewing Angle
Every 5 LEDs Draw ~25mA
Load Equalizer may be required
LIFETIME LED WARRANTY
SOLD AS A PAIR
Available for 39mm, 41mm, 43mm, 49mm, and 56mm forks
How To Measure
Use a string to wrap around the fork and mark where the string touches. Using a tape measure, measure the space between the start and end of the fork in millimeters. This measurement is the circumference. To get the diameter, use a calculator and divide the circumference by 3.14. The result is the diameter of your fork.
PACKAGE CONTENTSTruWRAPZ® (pair)
EPZ-WA Module (2)
Black #205 Heat Shrink Tubing (2)
Adhesive Primer Ampules (2)
Chrome Zip Ties (10)
Stainless Steel Wire Loom (6')
Wire Loom Grey Shrink Tubing (2)