In stock
SKU
STINGERZ15
Stingerz® Wheel Lights
EASILY MOUNTS TO BRAKE CALIPER
Stingerz® Wheel Lights contain 15 LEDs which illuminate 360 degrees around the outer edge of a round puck to project light on the wheel rim. Mounts to the inside of the front wheel brake caliper where there is a 5/8” clearance between the wheel and caliper. Each Stingerz® Wheel Light comes with 84” color coded wire leads in high temp protective black sheathing, have a waterproof conformal coating, and are pre-taped with 3M™ adhesive tape for a durable installation. All LEDs are backed by a lifetime warranty against LED failure. Sold Each.
Custom Dynamics® Red, Blue, Green, White, Orange, Purple, Pink and Yellow Stingerz® are available with either a chrome or black case to match the caliper.
Dimensions: 2.6” x 2.1” x .5”.
Add one of Custom Dynamics® single color accent light remotes for added functions and to control your lights from up to 100ft away.
Add adhesive primer to increase adhesion of 3M™ double-sided tape. For Chrome Brake Lines, add Stainless Steel Wire Loom and Chrome Zip Ties for a clean wiring job!
As low as
$19.95
EachWarning: Cancer & Reproductive Harm — www.p65warnings.ca.gov
Products Similar To This
Details & Fitment
Stingerz® Wheel Lights contain 15 LEDs which illuminate 360 degrees around the outer edge of a round puck to project light on the wheel rim. Mounts to the inside of the front wheel brake caliper where there is a 5/8” clearance between the wheel and caliper. Each Stingerz® Wheel Light comes with 84” color coded wire leads in high temp protective black sheathing, have a waterproof conformal coating, and are pre-taped with 3M™ adhesive tape for a durable installation. All LEDs are backed by a lifetime warranty against LED failure. Sold Each.
Custom Dynamics® Red, Blue, Green, White, Orange, Purple, Pink and Yellow Stingerz® are available with either a chrome or black case to match the caliper.
Dimensions: 2.6” x 2.1” x .5”.
Add one of Custom Dynamics® single color accent light remotes for added functions and to control your lights from up to 100ft away.
Add adhesive primer to increase adhesion of 3M™ double-sided tape. For Chrome Brake Lines, add Stainless Steel Wire Loom and Chrome Zip Ties for a clean wiring job!
Installation Instructions
Fitment
All Harley-Davidson® Brake Calipers (except: narrow glide front ends (Sportsters®, some Dynas®), and '06 and up V-Rods).
Also Fits Any Metric where the back side of the brake caliper is flat and there is 5/8" clearance between the caliper and wheel.
Compatible with 12VDC systems with a negative ground.
Specifications
1 CM LED SPACING
120 DEGREE VIEWING ANGLE
3MM LEDS
DIMENSIONS: 2.6" X 2.1" X 0.5"
84” COLOR CODED WIRE LEADS IN HIGH TEMP PROTECTIVE BLACK SHEATHING
12VDC SYSTEMS
LIFETIME LED WARRANTY
SOLD EACH
Dig Deeper
Videos
Write Your Own Review