Victory Motorcycle Turn Signal Load Equalizer

A Victory motorcycle may require a load equalizer when you replace the stock turn signals with LEDs. LED lights draw less power than incandescent bulbs, which can cause the flasher relay to blink too quickly. A load equalizer ensures the correct amount of resistance, allowing the turn signals to function properly and blink at the right speed. If you notice rapid blinking after making the switch to LEDs, it's a clear sign that you need one! Install one unit on your Victory motorcycle (as described below) to bring your new LED turn signals back to a smooth, normal flash rate. One unit needed per bike.

Required on 2005-2010 Victory® Vegas®, Kingpin, Hammer®, and Jackpot with two sets of LED turn signals

Required on 2011-2017 Victory® Vegas®, Kingpin, Hammer®, Jackpot, High-Ball®, and Gunner with one OR two sets of LED turn signals.

Victory® Cross Country, Cross Country Tour, Magnum and Vision models do NOT require a load equalizer.

2005 - 2010 Victory® Vegas®, Kingpin, Hammer®, and Jackpot with two sets of low current draw LED turn signals

2011 and newer Victory® Vegas®, Kingpin, Hammer®, Jackpot, High-Ball®, and Gunner with one OR two sets of low current draw LED turn signals.

Victory® Cross Country, Cross Country Tour, Magnum and Vision models do NOT require a load equalizer.

• WORKS WITH MOST LOW CURRENT DRAW LED TURN SIGNALS
• ONE UNIT NEEDED PER BIKE
• SOLD EACH

View product installation instructions